PR-1000 /2000/ GMRS antenna packages

GMRS Base & Mobile Antenna Packages Also fits Audiovox, Radio Shack, Cobra PR1000 / PR2000 and MANY others!
	GMRS MAG MOUNT #1M Qty: Price: $44.00 Similar to picture, 3 db gain antenna with integral magnetic mount & 12' low loss cable/ BNC push/twist-on connector Pre-cut for 465 mhz in center of gmrs band-no tuning required! Approximate length of this antenna is 34" Note:Some radios require a sma to bnc connector as an accessory $13.00 each

Not sure what connector your radio has? Click HERE for some pictures of common connectors!

Also available in:
Package #2M 3/4" hole mount version Qty: Price: $49.00 Required 3/4" hole drilled in body This is the best style antenna for maximum range.	Package #3M Right angle stainless bracket mount Qty: Price: $49.00 Use to mount on side panels, vertical surfaces, or inside fender panels-requires 3 small screw-holes-cannot be seen from outside the vehicle.
Package #4 Trunk lid mount Qty: Price: $49.00 No holes required-grips inside of body panel without damage.

*In Stock for immediate shipment!*
GMRS base antenna package #1B Comtelco fiberglass 2.5 db gain antenna with mount, 50' Ultralink low-loss cable, Silver connectors, wall brackets/vent pipe mount, and 5' pipe, connector sealant, roll of tape. This is a heavy duty base antenna- designed to last for many years! We've done this package for 15 years now and it has been very popular! GMRS base antenna package #1B Qty: Price: $244.00 (pictured) Ships UPS oversize and shipping may not be calculated properly by the shopping cart-(62" long) GMRS base antenna package #2B Comtelco mobile antenna with base station converter mount, 50' Ultralink low-loss cable, connectors, you supply mounting hardware/pipe, connector weather-proofing etc. This is a light duty/temporary base antenna. GMRS base antenna package #2B Qty: Price: $169.00
Additional cable length can be added to either base package for $.75 per foot. Ultralink Cable Qty: Price: $.75
Note: PR-1000/2000 radios and some others require a sma to bnc connector as an accessory. Can be used with base antenna but only with custom adaptor cable to eliminate stress on the connectors. Most base antenna cables are too stiff etc and will break these small connectors. CN3 SMA ADAPTOR Qty: Price: $13.00

Why use an external antenna? All stock rubber antennas on radios are poor radiators to begin with. When using a portable inside a vehicle, it becomes very difficult for the radio signal to penetrate inside the vehicle due to metal etc. An outside antenna will allow all the signal to be radiated from outside the vehicle, and will raise the antenna a few feet higher, producing better range! How much more range is a question often asked. Typically you can almost double the distance you get with a standard 5 watt radio! Range is relative to your surrounding terrain, buildings, etc. Most people notice a significant difference. Other dealers try to sell me a higher DB gain antenna, why don't you recommend this? High gain antennas have one problem. The higher the gain you go, the more compressed the radiation pattern is towards the horizon. In a typical radio system you don't want a high gain antenna, you want a lower gain antenna that will fill in the pattern closer to the horizon which is where you are trying to talk. High gain antennas can cause "multi-path" which is the signal arriving from more than one source at a time, and this can actually "cancel" the signal out that you're trying to receive. It also means that you could easily "over-shoot" where you're trying to talk to! We recommend 0-3 DB gain antennas for all systems, unless you're in the middle of the desert with no obstructions. Our antennas are rated over a radiator in free space, which is a more industry accepted method resulting in no "marketing hoopla" Also another problem found in the industry is the higher the gain antenna the longer it is.... and mechanical integrity becomes an important issue!